Fagerstrom English / Cornish Double Pipes
Fagerstrom Technopipes

Fagerstrom English / Cornish Double Pipes

0 Review(s) Write a Review
Your Price: $365.00
The chanter is available in an English double pipes version. A Cornish double pipes version with an additional lower hand thumb hole can be made on demand.
Part Number: be-ecdp
Availability: Special Order, Please allow 2 to 3 weeks to fill.
THE CONTACTS
The contacts on the chanter are electrical and not mechanical, meaning that they do not have to be pressed down to achieve contact. The grip does not have to be any firmer than that on the pipe chanter. The contacts are about 3mm in diameter, and with their highest point slightly above the surface of the pipe in order to get a better feel for their position. Worth mentioning is that there is no electrical "ground contact" on which a finger or any other part of the body has to rest on, or be connected to, whilst playing. 

PLAYING
You start the drone by playing a C, and then the chanter by playing a G (for pipes tuned to key of C). If you don't want the drone to sound you just play a C. If you want to shut the sound off briefly, just play the "off" fingering combination and it will go silent until you start playing again. 

SETTINGS/CONTROLS
There are two contacts that are used to control all settings. To adjust a setting, just hold the relevant fingering combination and use the control contacts.

The following can be controlled:
  • Sensitivity: Since the fingers sometimes can be very dry, causing them to become poor conductors, and sometimes quite sweaty, leaving a sweat film on the chanter short-circuiting the contacts, the sensitivity is possible to set. Most of the time though, the setting of the sensitivity can be ignored.
  • Pitch: the chanter is tuned to key of C (262Hz) as default. With Sound set to Smallpipes, the chanter starts in the key of A (220Hz). The low C/ low A goes from 93Hz up to 369Hz in steps of 0.1 to 0.7Hz. The key of the chanter can easily be set to D, F, G, A220Hz, or C. 
  • Metronome: easy to start in desired tempo. Sub-beats can be added.
  • Drone: volume relative to chanter. The single tenor drone is always in tune with and follows the key of the chanter. For a chanter with tonic in C, the tenor drone is in F. With Smallpipes sound in key of A, a tenor and a bass drone will sound in A.
  • Sound: douple pipes or Scottish Smallpipes.
  • Volume: affects chanter, drone, and metronome. 
  • Recording: more than 1200 notes can be recorded. During playback, the recorded notes are sounding on the right channel, and you can play along on the left. The playback speed can be set between ¼ and 2 times the recorded speed. NB.When playing back English pipes sound, the drone does not sound.
MIDI
MIDI (Musical Instrument Digital Interface) is an electronic communications protocol that enables electronic musical instruments, computers, and synthezises etc. to communicate with each other. MIDI does not transmit an audio signal - it transmits digital data messages defining parameters such as pitch and volume of the musical notes to play. See http://www.midi.org for further reading.

You enter MIDI mode by holding a specific fingering combination and then inserting the MIDI cable plug to switch the chanter on.
The chanter is initially set to channel 1, but can be set between 1 and 14. The bass is fixed on channel 15.
In MIDI mode the metronome and recording are not available.
The pitch is adjusted in semi-notes.
The volume settings for chanter and drone affect the "velocity" of the MIDI note. On some devices the velocity is the same as the volume for the note, on others it isn't. It is up to the receiving device to interpret the velocity data.
In MIDI mode the power consumption is lower and the chanter will run for approx. 20 hours on a rechargeable 1000mAh NiMH battery. 

DIMENSIONS
The length of the pipe is 249mm and the diameter is 16mm. The dimensions together with the low weight of approx. 60 grams, make this chanter very portable indeed. 

ADDITIONAL INFORMATION
The manual:SOUND SAMPLES

Related Items

McCallum AB4 Blackwood Bagpipes
(0)
$1,469.00
Custom Made to Order. Delivery generally takes about 10 to 12 weeks.
R.G. Hardie 04 A.B. Great Highland Bagpipes
(0)
$1,420.00
Custom Made to Order. Delivery generally takes about 2 to 4 weeks.
SL3 - MacRae Bagpipes Imitation Ivory Projection Mounts, Ring, Caps, and Ferrules
(0)
$1,339.00
Custom Made to Order. Delivery generally takes about 10 to 12 weeks.
SL4 - MacRae Bagpipes Imitation Ivory Projection Mounts, Engraved Alloy Ferrules, Engraved Ring Caps, Engraved Slides
(1)
$1,589.00
Custom Made to Order. Delivery generally takes about 10 to 12 weeks.
Two or Three Drone MacLellan Studio Pipes with Imitation Ivory or Horn mounts
(0)
$825.00
Custom Made to Order. Delivery generally takes about 2 to 3 months.

Recently Viewed Items

Mailing List

TOP